Jerry-Rig™ USA, LLC
P.O. Box 335   Mt. Freedom, NJ   07970-0335
Phone:  973-895-2818   Fax:  973-895-1917   Email: Jerry-Rig™



Tapered Carving Screws

Jerry-Rig's™ tapered carving screws are the better alternative to the conventional carving screw. The tapered part of the screw is turned into a pre-drilled hole in the base or back of the carving and tightened by using the hole in the ‘T’ handle. When the screw has penetrated the wood deep enough for secure holding, the rest of the screw is passed through a hole in a bench or a slot on the carving arm. The ‘T’ handle, which is also the nut, is then threaded onto the screw until the work is pulled tight against the bench. Considerable pressure can be put on the screw by tightening the ’T’ nut. If the carving needs to be rotated, loosen the wing nut and position the carving, then tighten again. No need to drill a deeper hole like conventional carving screws.

  • Holds more tightly than a straight screw

  • Two sizes, 6 3/4" for small to medium carvings, and 9" for larger carvings

  • High quality construction with cadmium plating on the screw

  • Rugged ‘T’ handle wrench, for driving in the screw, is black powder coated for protection

  • Plastic tips on the ‘T’ handle wrench for safety and easy gripping

  • Compatible with most carving arms

  • P/N for small screw is JR-CSM

  • P/N for large screw is JR-SCL

  • Click here to view a line drawing of our 6 9/16" tapered carving screw

  • Click here to view another line drawing of our 9 1/8" tapered carving screw

 

Copyright 2007 - All rights reserved. Legal / Contact Us